Skip to content

v0.14 Release Notes

[0.14.0]

Added

  • AIREOSDevice show method now supports sending any additional args that Netmiko supports using kwargs.
  • AIREOSDevice is_active method was added to check if device is the active device.
  • EOSDevice now supports specifying the connection port.
  • IOSDevice show method now supports sending any additional args that Netmiko supports using kwargs.
  • IOSDevice is_active method was added to check if device is currently the active in a HA setup.
  • IOSDevice redundancy_mode, redundancy_state, and peer_redundancy_properties are now available.

Changed

  • AIREOSDevice sending commands with expected prompt is now done via Netmiko's send_command method.
  • AIREOSDevice now waits for peer to form after upgrade before failing due to peer redundancy issues.
  • AIREOSDevice file_copy method offers more granular failures to help identify where failures happen.
  • AIREOSDevice peer_redundancy_state method now returns None if the unit does not support redundancy.
  • AIREOSDevice redundancy_state method now returns a string of the state or None if it is not supported.
  • AIREOSDevice is_active method should be used for functionality previously supported by redundancy_state.
  • AIREOSDevice open method now allows the default behavior of checking that device is active to be turned off using confirm_active arg.
  • AIREOSDevice show method no longer supports passing expect arg, as that is implied by passing expect_string.
  • ASADevice sending commands with expected prompt is now done via Netmiko's send_command method.
  • ASADevice show method no longer supports passing expect arg, as that is implied by passing expect_string.
  • IOSDevice fetching the default file system now tries 5 times before raising an exception.
  • IOSDevice sending commands with expected prompt is now done via Netmiko's send_command method.
  • IOSDevice waiting for device to reboot now waits until "show version" command is successful (delayed startup).
  • IOSDevice file_copy method will attempt md5 validation if copy completes even though network device closes the socket.
  • IOSDevice open method now defaults to checking that device is active; use the confirm_active arg to change this.
  • IOSDevice show method no longer supports passing expect arg, as that is implied by passing expect_string.